Scan control unit for fault codes. Determine codes set for DPF dirty. Ready car and run complete regeneration of DPF. Regen was successful. Test drive for 5 miles and watch system pressures. All good at this time.
Alex P. gave our service a 5 star review on 8/14/2020
Remove four tires. Mount and balance new tires. Inspect brake rotors and pads. Inspect any suspension issues visable with wheels off of vehicle. Re-install tires. Reset tire pressure monitor system. Test drive vehicle.
Replace Front brake pads. Inspect condition and thickness of front brake disc rotors. Retract rear brake caliper actuators. Clean and lubricate rear brake caliper slide mechanism. Adjust parking brake. Road test vehicle.
Replace rear brake pads and rear rotors. Free-up rear brake calipers and rear slider assemblies. Repack rear wheel bearings as necessary. Check and lube parking brake mechanism and brake cables.
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber angles and adjust as required. Check and set toe-in as required. Center steering wheel.
Kim R. gave our service a 5 star review on 8/10/2020
Determine the transmission oil cooler to have failed and contaminated the complete cooling system with transmission fluid. Drain and flush complete system. Replace radiator under GOODWILL Warranty.
MICHAEL C. gave our service a 5 star review on 8/6/2020
Complete 65,000 mile maintenance service. Change engine oil and filter with BMW synthetic oil. Check all fluids. Tune-up engine complete. Replace spark plugs. Replace engine air filters and charcoal cabin filters. Lubricate chassis where possible. Check belts. Check wheel bearings. All adjustments and chassis items serviced per the manufacturers requirements. Road test vehicle.
Replace rear brake pads and rear rotors. Free-up rear brake calipers and rear slider assemblies. Repack rear wheel bearings as necessary. Check and lube parking brake mechanism and brake cables.
Scott A. gave our service a 5 star review on 8/4/2020
Fault codes set for defective oxygen sensor heater in B1S1 oxygen sensor.
Replace rear brake pads and rear rotors. Disassemble and free-up rear brake calipers and rear slider assemblies. Repack rear wheel bearings as necessary. Check and lube parking brake mechanism and brake cables. Brake cables are bad and cannot be connected.
Test complete electrical system. Determoine the high voltage electrical panel to be defective. Replace panel and reset all fault codes.
Alan E. gave our service a 5 star review on 7/26/2020